General Details

Extra product information

The spool holds the thread for easier threading.
The metal threader is elevated on a plastic mount for easier threading.
The magnifying glass is mounted in front of the threader on a stand and makes it easier to see the threading process.
On the backboard there is a moulded plastic holding seam to hold the end of the thread and also a cutter for cutting the thread.
It would be best mounted at eye height if you need to use the magnifying glass.

Method of Use

Step 1: Adjust the magnifier at your best view.
Step 2: Pass the needle eye through the loop of the threader.
Step 3: Guide the thread from the spool through the loop of the threader about 125mm (or a bit longer)
Step 4: Gently raise the needle.
Step 5: After the needle comes out from the threader loop, it will create a thread loop through the needle eye.
Step 6: Pull out one end of the thread from the needle eye and the threader loop.
Step 7: Adjust the length of the thread you need and fix the end of the thread by inserting it into the holding seam, then cut it using the cutter on the back board. You may use a small pair of scissors instead if it's easier.
(Illustrated instructions are on the suppliers web site)

Manufacturer/Country

Australia

Maintenance

Refer to the supplier and manufacturer manual for maintenance instructions and safety warnings.

Models / Specifications