A pressure cushion with a wireless sensor device designed to alert the carer that a person is getting out of the chair. The supplier states it is appropriate for users who have a low risk of developing pressure ulcers. Other options are available.
General Details
Maintenance
Refer to the supplier and manufacturer manual for maintenance instructions and safety warnings.
Extra product information
Components:
Pressure cushion to detect chair occupancy via buzzer alarm.
Receiver which has up to 12 metres range from the cushion.
Power pack which connects the receiver to the mains power.
Cover
Top cover is made from a two way stretch material.
Waterproof and vapour permeable.
Bottom cover is made from vinyl.
Power
Receiver needs to be connected to a 240V mains power at all times.
Power back up up to 3 hours in case of power failure.
Cleaning instruction
Clean with Pine-o-clean wipe or similar type wet cloth.
Factors to Consider
This system is an aid only and does not replace adequate supervision.
Supplier states that it is appropriate for users who are at low risk of developing pressure ulcers.
Ensure that any cords and leads are secured as trailing leads can create a trip hazard.
Options
Can be supplied with multiple channel receivers.
Can be hard wired into the home electrical system.
Installation
Do it yourself installation.
Method of Use
Cushion is placed on top of the chair.
The receiver can be located where the carer can see or hear the alarm. It must be within 12 metres distance from the cushion.
When user is sitting on cushion, the four switches are on.
When pressure on cushion is off, the switches sends a signal to the transmitter.
The transmitter will activate the receiver via wireless infra-red signal and the buzzer or strobe light is on.
The carer must switch off the receiver to stop the alarm.
The receiver can then be switched on again to reset the settings.
Manufacturer/Country
Australia
Warranty
Contact Supplier for Details
Websites
Maintenance
Refer to the supplier and manufacturer manual for maintenance instructions and safety warnings.
Models / Specifications
Model 880: One model only
Suppliers (1)
Select a state below to view suppliers located in that state. Some suppliers may distribute to other states or nationally. Please click the supplier's name for more information on that supplier.
All Suppliers
Biovations Pty Ltd (Sandown Village)
| Supplier Code | Price & Price Notes | Hire? | Repair? | Availability |
|---|---|---|---|---|
| 0.0 - 0.0 | unknown | unknown |
VIC Suppliers
Biovations Pty Ltd (Sandown Village)
| Supplier Code | Price & Price Notes | Hire? | Repair? | Availability |
|---|---|---|---|---|
| 0.0 - 0.0 | unknown | unknown |
Standards
Some assistive technology needs to meet Australian or other standards. Standards may relate to materials, manufacturing, and installation. Products that meet Australian or international standards will have written certification. To find out if a product meets Australian Standards ask the supplier to show you the certificate. For more information about standards see http://www.ilcaustralia.org.au/Using_Assistive_Technology/standards_regulation
Disclaimer
Independent Living Centres Australia (ILCA) does not design or make products. ILCA cannot guarantee that all information given is correct. Prices shown are a rough guide. Some products may incur GST. Check with suppliers for up-to-date prices. The display of products at an ILCA centre, or details given in print, is only for your information. It is not a recommendation. You should always get professional advice when choosing products. The person choosing the product is responsible for their choice. ILCA takes no responsibility for people choosing equipment or services which will cause (or be alleged to have caused) loss or injury. You must follow the manufacturer’s or service provider’s instructions when using equipment or services.